I bought an AR620 receiver and a Spektrum DXE transmitter. I found out that throotle is on pin 3, rudder on pin 2, aileron on pin 4, nothing on pin 1, flight mode on pin 5 and the bind / panic / trainer button on pin 6. Elevator is not found. However, I can not fly my plane without an elevator. I can not connect the receiver to the programming software, but the transmitter already. Can someone help me? Thank you
Announcement
Collapse
No announcement yet.
rudder channel has no port on receiver
Collapse
X
-
Hi HelloWord, welcome to Hobby Squawk!
Would you attach a photo of your radio's setup? The AR620 receiver is labeled with which port corresponds to which control input. I don't know what you mean by "Elevator not found"... the "ELE" port would be clearly labeled on your receiver, which leads me to think your radio's model setup is somehow incorrect. Create a new model and try binding to the receiver separately.Live Q&A every Tuesday and Friday at 9pm EST on my Twitch Livestream
Live chat with me and other RC Nuts on my Discord
Camp my Instagram @Alpha.Makes
-
The new AR620 has no labels for output, just numbers.... 1 is throttle, 2 is aileron, 3 is elevator, 4 is rudder, 5 is gear and 6 is flaps (Aux 1) I hope this helps some.... :Cool: Start with a new model and memory cleared and bind to the new receiver. Use a spare servo and plug into each channel and check the corresponding stick movements and verify servo output movement. This will work on the throttle channel as well... Jerry
(Old school throttle servo) :P1 Photo
Comment
-
Sorry for the issues... It really sounds like a problem with the TX programming. Have you selected another "new" model and cleared the memory? Have you set it for "airplane"? Wing type "normal" No mixes... Then rebind it to your receiver and test it that way? I have no other suggestions for you if that doesn't work, other than a bad receiver... Good luck.. And welcome to Hobby Squawk!!!! Glad to have you on board!!!
Comment
-
Originally posted by HelloWordWithProblems View PostThis is with ESC on battery port and servo on one of the servo ports
Comment
-
I've fixed it. The cannels are where they have to be. I managed it with pressing the bind button, powering on the transmitter and pulling the aileron stick to the side at the same time. But Channel 1 doesn't work. I'm sure this is a hardware problem and I will try to fix it tomorrow. But this post is closed.
- Likes 1
Comment
Comment