Hello,
My first plane is a Timber 1.5 BNF and I'm getting pretty good at flying it, and wanted to know how high I was flying etc.
So went on Horizon Hobby website and asked the question via chat and sales guy said that the TM1000 along with the SPMA9589 Telemetry Variometer would do the trick and that it would work with my 636A receiver.
Parts arrived and I plugged TM1000 data cord into the Bind port of the 636A and then Variometer into Data port of the TM1000.
Went thru Bind process and it says it is binding,but I get no telemetry data from the receiver to the Transmitter.
I saw a video where a guy used a splitter (Y cord) from Bind port and ran 1 leg to the TM1000 and the other leg had the bind plug in it, and it had same results.
I dont have a volt / RPM utility in the TM1000, so wondering if that could be the case?
I dont want to have to buy a temp / RMP / volt attachment if it is not needed, I was only looking for the altitude.
To bind, it is just hold down the bind button on the TM1000 while powering up the receiver, and then when TM1000 is blinking, power up transmitter holding down bind button.
Any insights?
My first plane is a Timber 1.5 BNF and I'm getting pretty good at flying it, and wanted to know how high I was flying etc.
So went on Horizon Hobby website and asked the question via chat and sales guy said that the TM1000 along with the SPMA9589 Telemetry Variometer would do the trick and that it would work with my 636A receiver.
Parts arrived and I plugged TM1000 data cord into the Bind port of the 636A and then Variometer into Data port of the TM1000.
Went thru Bind process and it says it is binding,but I get no telemetry data from the receiver to the Transmitter.
I saw a video where a guy used a splitter (Y cord) from Bind port and ran 1 leg to the TM1000 and the other leg had the bind plug in it, and it had same results.
I dont have a volt / RPM utility in the TM1000, so wondering if that could be the case?
I dont want to have to buy a temp / RMP / volt attachment if it is not needed, I was only looking for the altitude.
To bind, it is just hold down the bind button on the TM1000 while powering up the receiver, and then when TM1000 is blinking, power up transmitter holding down bind button.
Any insights?
Comment