Just installed one of the new RXs recieved a couple of days ago.
DX 18 detected it properly as a DSMX telemetry RX.
I went in the TX telemetry menue and had it autodetect the telemetry sensors, which it appears to have done properly.
Temp probe gives temp that follows a thermometer beside the probe.
RX voltage matches a multimeter connected th a servo port.
Motor battery matches what the voltmeter says for the LiPo.
But nothing from the current sensor.
Its not my first Admiral telemetry RX, but is the first attempt to get the current sensor to work. I haven't used the telemetry in models with low enough max current previously.
DX 18 detected it properly as a DSMX telemetry RX.
I went in the TX telemetry menue and had it autodetect the telemetry sensors, which it appears to have done properly.
Temp probe gives temp that follows a thermometer beside the probe.
RX voltage matches a multimeter connected th a servo port.
Motor battery matches what the voltmeter says for the LiPo.
But nothing from the current sensor.
Its not my first Admiral telemetry RX, but is the first attempt to get the current sensor to work. I haven't used the telemetry in models with low enough max current previously.