jimS, I share your concern about not having an instruction manual in the box (the first model I have had that happen) although the assembly video did a pretty good job of explaining the assembly. Like your plane my elevator and rudder servo lead labels were reversed, and upon assembly and initial motor run (in my hangar) with the spinner on as tight as I could get it with my hand, the prop flew off when I cut the throttle. I was aware of this problem upon reading another review but I find it unacceptable for a quality model. One reviewer suggested using Locktite but I didn't want to use that if possible. Since my TX (DX8) has a "Speed" adjustment under the Servo Setup Function, I moved my throttle Speed from "normal" to "2 secs." This means it slows the servo response time from instantaneous to 2 seconds giving a more gentle slowing of the prop and keeping it attached to the plane. (I do hope Skynetic will address this problem and modify the spinner assembly as necessary.) I hope this helps if your TX has some kind of speed adjustment. Otherwise, it may have to be Locktite.
Also, I had trouble attaching the servo pushrod clips on this model as I am used to larger diameter rods and clips which are easier with my fat fingers. I had to use a pin-nose pliers to get them fully clipped. You will usually feel/hear a snap when they do clip fully in place. With the thin wire pushrods on the Shrike be careful, however, not to bend the rods if you use pliers.
BTW good luck to you and your grandson as you introduce him to the the absolute joy of flying airplanes, whether full scale or RC. I can tell by the look on his face in your photo that he truly is pilot material and should go far in the field of aviation, if he so chooses! Happy landings!
Also, I had trouble attaching the servo pushrod clips on this model as I am used to larger diameter rods and clips which are easier with my fat fingers. I had to use a pin-nose pliers to get them fully clipped. You will usually feel/hear a snap when they do clip fully in place. With the thin wire pushrods on the Shrike be careful, however, not to bend the rods if you use pliers.
BTW good luck to you and your grandson as you introduce him to the the absolute joy of flying airplanes, whether full scale or RC. I can tell by the look on his face in your photo that he truly is pilot material and should go far in the field of aviation, if he so chooses! Happy landings!
Comment