I purchased an e-flite focke wulf bind and fly
and have been having some issues ,
the transmitter I have is a spektrum nx6 ,
I was able to create model and bind it successfully but
not able to finish up manual adjusts or fly it ,
started getting control surface flutter ,
I contacted horizon and they determined faulty reciever,
I waited for programming on the ar637t and the shipped to me , installed unit and had same result ,
so I contacted customer service again , and they determined this time the esc !!
i recieved it , put it in plane and still had control surface glitch .
so I grabbed another battery thinking it could be a volt issue , still having issue .
At this point I looked further and noticed transmitter showing signal fluctuations coinciding with control surface flutter ,,,,,
ok sqwak forum ,, how do I
get this issue to go away ?
Frustrated in Maine
and have been having some issues ,
the transmitter I have is a spektrum nx6 ,
I was able to create model and bind it successfully but
not able to finish up manual adjusts or fly it ,
started getting control surface flutter ,
I contacted horizon and they determined faulty reciever,
I waited for programming on the ar637t and the shipped to me , installed unit and had same result ,
so I contacted customer service again , and they determined this time the esc !!
i recieved it , put it in plane and still had control surface glitch .
so I grabbed another battery thinking it could be a volt issue , still having issue .
At this point I looked further and noticed transmitter showing signal fluctuations coinciding with control surface flutter ,,,,,
ok sqwak forum ,, how do I
get this issue to go away ?
Frustrated in Maine
Comment