OV-10 esc problem

Collapse
X
Collapse
First Prev Next Last
 
  • Time
  • Show
Clear All
new posts
  • Bill J
    Member
    • Feb 2025
    • 1
    • Send PM

    #1

    OV-10 esc problem

    Just purchased the OV-10 and have an issue with the right esc. After about 20 seconds at 1/3 power the right one shuts off and starts beeping. If shut power down and throttle back up it will do the same thing. I watched the esc programming video and removed the props and re calibrated them. Ran it them up for 3 minutes and everything was good. Put the props back on and ran them for about 1-1/2 minutes and it did it again. Anyone else had this problem? I’m using brand new 4 cell 40000 batteries and a spectrum ar630 receiver.
  • GloriaCalton
    Member
    • May 2025
    • 1
    • Send PM

    #2
    Originally posted by Bill J
    Just purchased the OV-10 and have an issue with the right esc. After about 20 seconds at 1/3 power the right one shuts off and starts beeping. If shut power down and throttle back up it will do the same thing. I watched the esc programming video and removed the props and re calibrated them. Ran it them up for 3 minutes and everything was good. Put the props back on and ran them for about 1-1/2 minutes and it did it again. Anyone else had this problem? I’m using brand new 4 cell 40000 batteries and a spectrum ar630 receiver.
    Try running without the fan attached to determine if the problem is caused by drag from the fan.
    ​​

    Comment

    Working...