Hello!
I just assembled my new Tech One Revolution!
Does anybody know what the control surface rates should be set at for the ail, rudder and elevator for high and low flight modes...It doesn't say anything in the manual about throw distance of anything... I would like to be on a low rate setup at first to get used to it so i can keep it under control as I am just a learning pilot! I didn't want to guess at it as I have a few planes and all their rates are so different from the other planes I couldn't fathom to guess what to set it at to be ok etc...
I have a deflection gauge and can set it to inches or mm for each if I know the right values!
Thanks!
Ron
I just assembled my new Tech One Revolution!
Does anybody know what the control surface rates should be set at for the ail, rudder and elevator for high and low flight modes...It doesn't say anything in the manual about throw distance of anything... I would like to be on a low rate setup at first to get used to it so i can keep it under control as I am just a learning pilot! I didn't want to guess at it as I have a few planes and all their rates are so different from the other planes I couldn't fathom to guess what to set it at to be ok etc...
I have a deflection gauge and can set it to inches or mm for each if I know the right values!
Thanks!
Ron