Dynam Bf-110 motor issues

Collapse
X
Collapse
First Prev Next Last
 
  • Time
  • Show
Clear All
new posts

  • TSHobbies
    replied
    lol, well, thanks, but that plane was sold off along time ago.

    Leave a comment:


  • fieldofdreamsflyer
    replied
    Originally posted by TSHobbies
    RE: Dynam Bf-110 motor issues

    I followed the video to reset the ESCs,but I think that method sets them to medium...how do you set it to low?
    Med should work fine , dont put it to low cause you will lose top power

    Leave a comment:


  • fhhuber
    replied
    RE: Dynam Bf-110 motor issues

    Just get the ESC programming card... especially if you have a few of the Dynam ESCs it is well worth having.

    Turnigy's programming card that looks the same is the same. (I have both) Cross-matches to several of the Chinese ESCs.

    To safely test an ESC programming card on a different brand ESC: Note the light settings when you first use the card. If the results of changing the "I'm alive" music setting is not appropriate then put it back the way it was.
    You could actually develop a set of notes for the different effects of using the card with any ESC that can be programmed by a card. They just change the order of the buttons.

    Leave a comment:


  • TSHobbies
    replied
    RE: Dynam Bf-110 motor issues

    mine didnt come with that manual

    Leave a comment:


  • OV10
    replied
    RE: Dynam Bf-110 motor issues

    Hello TSH,
    All the Dynam's that I have came with an inclusive document in the assembly manual called " Manual of Brushless Motor Speed Controller" or a separate pamphlet titled the same. If you are not comfortable programming the ESC's via your transmitter and listening/interpreting sounds then get this programming card.
    http://www.motionrc.com/dynam-esc-programming-card/
    Best regards,

    Leave a comment:


  • TSHobbies
    replied
    RE: Dynam Bf-110 motor issues

    I followed the video to reset the ESCs,but I think that method sets them to medium...how do you set it to low?

    Leave a comment:


  • OV10
    replied
    RE: Dynam Bf-110 motor issues

    Hello TSH,
    Dynam 30 and 40amp ESC's will demonstrate that pulsing characteristic more often than not if the 'timing' is not set for LOW. The higher rated amperage ones seem to be fine.
    Best regards,

    Leave a comment:


  • TSHobbies
    replied
    RE: Dynam Bf-110 motor issues

    yes I have. and its connected securely.


    Originally posted by Ryan@Motion/ryramZ
    Originally posted by TSHobbies
    hey guys..finally got the 110 together ,wired up and ready to ground test it..but having motor issues. I followed the steps in the video on MRs site about resetting it to factory, but that didnt work..In fact,mines not really acting like that.. what both motors are doing is stuttering , acting like they want to go in both directions..meaning, they stutter one way,then go back the other direction ,and repeat..if I advance the throttle further, they either stop working,or just delay,and go back to stuttering. any ideas whats might be going on here?


    [hr]
    Heres what its doing,sorry for the poor quality

    https://youtu.be/JIBdr5Vp3CY
    Have you also calibrated the ESCs? It kind of sounds like a bad connection.

    Leave a comment:


  • ryramZ
    replied
    RE: Dynam Bf-110 motor issues

    Originally posted by TSHobbies
    hey guys..finally got the 110 together ,wired up and ready to ground test it..but having motor issues. I followed the steps in the video on MRs site about resetting it to factory, but that didnt work..In fact,mines not really acting like that.. what both motors are doing is stuttering , acting like they want to go in both directions..meaning, they stutter one way,then go back the other direction ,and repeat..if I advance the throttle further, they either stop working,or just delay,and go back to stuttering. any ideas whats might be going on here?

    [hr]
    Heres what its doing,sorry for the poor quality

    https://youtu.be/JIBdr5Vp3CY
    Have you also calibrated the ESCs? It kind of sounds like a bad connection.

    Leave a comment:


  • TSHobbies
    started a topic Dynam Bf-110 motor issues

    Dynam Bf-110 motor issues

    hey guys..finally got the 110 together ,wired up and ready to ground test it..but having motor issues. I followed the steps in the video on MRs site about resetting it to factory, but that didnt work..In fact,mines not really acting like that.. what both motors are doing is stuttering , acting like they want to go in both directions..meaning, they stutter one way,then go back the other direction ,and repeat..if I advance the throttle further, they either stop working,or just delay,and go back to stuttering. any ideas whats might be going on here?
    [hr]
    Heres what its doing,sorry for the poor quality

    https://youtu.be/JIBdr5Vp3CY
Working...