Does anyone know how to correctly instal the ball bearings on the rear section of the stuffing tube on the Bancroft Madflow V3 rc boat? My flex shaft snapped testing out a 40mm 1.9 pitch prop and the rear section of the flex shaft and prop was lost in the pond I was running it in. I went to replace the flex shaft and stuffing tube and saw that 2 ball bearings fell out of the rear of the boat along with the short black plastic tube. I ordered a new set of ball bearings from Motion RC and noticed that it was a pack of 4. 2 small ones and 2 slightly larger ones. Wondering if I lost the other 2 ball bearings in the pond. Any help would be much appreciated since I’m new to the rc boat world.
You must Sign-in or Register to post messages in the Hobby Squawk community
Registration is FREE and only takes a few moments
