Timing and Poles for 9 blade EDF 3658-1920KV

[kalua]

Hi everyone,
i am looking for the needed settings for the 3658-1920KV Motor. Too bad i can't find it in the manual or on the motionrc website.
What i need is the number of poles and the timing in degrees.
Can please someone confirm that this Motor has 4 poles ? and i would set the timing between 5 and 10 degrees ?
There is no autotiming or low, middle, high timing for this esc.

best regards,
Mike

[Mizer67]

I can't find any information either. Hobbywing/Freewing ESCs are set on "Low" timing from the factory.

I think you'll be fine at between 5 and 10 degrees. Unsure of the number of poles, but I would guess 4 also.

[kalua]

Hi Mizer67,
thanks for your answer!
4 poles and 8° timing were doing fine.
Best regards,
Mike

[XTEAM Tom]

Hi everyone,
i am looking for the needed settings for the 3658-1920KV Motor. Too bad i can't find it in the manual or on the motionrc website.
What i need is the number of poles and the timing in degrees.
Can please someone confirm that this Motor has 4 poles ? and i would set the timing between 5 and 10 degrees ?
There is no autotiming or low, middle, high timing for this esc.

best regards,
Mike

how about the xteam3660 (1050kv--------4050kv),4foles