Hi all,
Question......
I have just purchased the Detrum Gavin 6c with the SR86A (gyro) receiver. I have installed it as per the instructions but have noticed that when the plane experiences a bit of turbulence in windy conditions the receiver stops acting as a gyro and reverts to "receiver" mode.
I have tested this in the house (wobbling the plane side to side, up and down & rolling left and right) with the gyro setting enabled....the same thing happens, the receiver momentarily loses signal, starts to flash green as it looks for a signal and tries to re-calibrate itself.
This is obviously very concerning as I don't want the system to fail while it is in flight if I flick it to the recovery setting. I have the Ailerons connected via a Y-Split .
Do any of you think this could be a wiring issue of a faulty receiver??
Any help or advice you can give would be very well received.
Question......
I have just purchased the Detrum Gavin 6c with the SR86A (gyro) receiver. I have installed it as per the instructions but have noticed that when the plane experiences a bit of turbulence in windy conditions the receiver stops acting as a gyro and reverts to "receiver" mode.
I have tested this in the house (wobbling the plane side to side, up and down & rolling left and right) with the gyro setting enabled....the same thing happens, the receiver momentarily loses signal, starts to flash green as it looks for a signal and tries to re-calibrate itself.
This is obviously very concerning as I don't want the system to fail while it is in flight if I flick it to the recovery setting. I have the Ailerons connected via a Y-Split .
Do any of you think this could be a wiring issue of a faulty receiver??
Any help or advice you can give would be very well received.
Comment