3D Printed Parts-Freewing F-18 90mm Hornet

[Radar-Guy]

This tread is intended for the sharing of .stl files to enhance the performance and looks of the Freewing F-18 90mm Hornet. Please add you contributions here.

Frank

[Radar-Guy]

Main Wheel Covers

This file has been already published, but I think it's OK to have it here as well.
The wheel needs a bit of surgery. On one side you need to grind off some material from the center (see pic blw). As the wheel I used came without bushing I inserted some 5mm OD brass tubing.

[Radar-Guy]

LEX Fences

The base plate can also be used with the stock plastic parts. Just remove the marked sections and it will fit into the base part.

[Twister006]

Radar-Guy any progress on the F/A-18 cockpit? I saw your post in the Hornet page and it looked great! Would love to add to my planes.

[Radar-Guy]

Last week I’ve heard about a very strange MRC-internal move against an employee of the European warehouse, which affects also in some way a group of enthusiastic modellers (including myself) over here in Europe. Thus, I’ve decided to stop my activities on this forum.

Frank

[Elbee]

Last week I’ve heard about a very strange MRC-internal move against an employee of the European warehouse, which affects also in some way a group of enthusiastic modellers (including myself) over here in Europe. Thus, I’ve decided to stop my activities on this forum.Frank

RG, Sorry to read you're leaving. The modelling community in general here will be poorer for it. I trust one day you might reconsider. Until then, RG, farewell and best always, LB