Need advice

[Reptielenfreak]

I have seen it, i did similar mod but in the sides of its belly👍

[Reptielenfreak]

Topic can be closed. I baught the Freewing F22, 3d printed the front gear brace and swapped the front gear with the one from the Zeus 90mm. Fly's really good, only thing was the one maingear ripped out after the second landing, haha. Fixed it with some 5min epoxy and away i went again.
did about 5 flights with gensace 5600 80C. @3.30min flight time.

[kallend]

Topic can be closed. I baught the Freewing F22, 3d printed the front gear brace and swapped the front gear with the one from the Zeus 90mm. Fly's really good, only thing was the one maingear ripped out after the second landing, haha. Fixed it with some 5min epoxy and away i went again.
did about 5 flights with gensace 5600 80C. @3.30min flight time.

Adhesives must be in short supply in China. Minimal glue on retract mounts is very common.

Epoxies don't work all that well on EPO. You are better off using Gorilla, or something like Foam Tac.