FMS T-28

[n99jh1]

I am trying to install the FMS New Multi Port Connector in my T-28 but am confused with channels 2, 5 and 6. Channel 5 has 3 female connectors in the fuselage and the board has 5B and 5C marked on it, how does that work?
Channel 6 also have connectors in the fuse as well, where do they go?
In the wing there are 3 connectors marked Channel 2, do they have to be connected to the board every time I plan on flying this plane?
Any help with this will be greatly appreciated.
Thanks
Josh

[OV10]

RE: FMS T-28

Hello n99jh1,
Welcome to the forum.
One of the first spots to check for advice or guidance on Motion RC(also referred to as MRC) product is via the product videos. In this case of the FMS T-28 you can find help via the spare parts tab for that connector where pilot Ryan has a rather detailed installation video. Here's the link:
http://www.motionrc.com/fms-new-multi-port-connector/

Good luck,

[n99jh1]

RE: FMS T-28

Hello n99jh1,
Welcome to the forum.
One of the first spots to check for advice or guidance on Motion RC(also referred to as MRC) product is via the product videos. In this case of the FMS T-28 you can find help via the spare parts tab for that connector where pilot Ryan has a rather detailed installation video. Here's the link:
http://www.motionrc.com/fms-new-multi-port-connector/

Good luck,

Thanks Charlie.
I checked the video before asking here. Problem is that Pilot Ryan used an old version P-51 that had no comparison to the T-28.
In any event, after about 3 hours of trying different approaches I now only have 3 connectors to plug when attaching the wing instead of 9 :)