Ov-10 flap issue…

[Flyboy82]

I’m a novice pilot so don’t come down to hard on me.
I have a flight line ov-10 im trying to set up and having trouble getting zeroed out I’ve got a Spektrum ar637t rx and when I bind It to my nx8 the flaps go way down like almost to landing position when I bind it to my dx6 this Dosent happen so I’m assuming user error with my new tx I know hardly nothing about. Any help would be much appreciated!!! But it’s like I don’t even have a good starting point to slate them up correctly.

[Evan D]

Sounds like you need to reverse the channel.

[Flyboy82]

Yeh I tried reversing the channel, that’s actually when I realized I set up my plane wrong with One aileron, and two flaps. It actually comes out of a tri lead into only one. So I have the wing set up on one flap one aileron but still couldn’t figure it out. Might just start over fresh probably something I did!

[Evan D]

If you do it by the book it’s one aileron, I one flap, one elevator, one rudder and the mixing is part blue box part Y’s.