Installation of the Dr Mad Thrust machine gun led lights with sound and the UBec with switch on the FMS P-51b Dallas Darling, 1400mm.
1. Remove Gun barrels from leading edge and drill out
2. Remove side cooling holes on both sides of the nose.
3. Fish speaker wire into fuse and place speaker inside. It will straddle the sides. Hot glue on both side to secure speaker.
4. Hot glue LEDs to back of MG holes
5. Cut channels in foam to route wires
6. Grind a little of plastic spar in leading edge of inboard gun so wires can pass
7. Fish everything through fuse to hook up UBec.
I placed UBec forward of the main board away from receiver per instructions. All of the extra wires and little panels can go all the way forward. It fits nicely under the battery tray
1. Remove Gun barrels from leading edge and drill out
2. Remove side cooling holes on both sides of the nose.
3. Fish speaker wire into fuse and place speaker inside. It will straddle the sides. Hot glue on both side to secure speaker.
4. Hot glue LEDs to back of MG holes
5. Cut channels in foam to route wires
6. Grind a little of plastic spar in leading edge of inboard gun so wires can pass
7. Fish everything through fuse to hook up UBec.
I placed UBec forward of the main board away from receiver per instructions. All of the extra wires and little panels can go all the way forward. It fits nicely under the battery tray
Comment