Hi guys, after the lift of a few seconds later, the heli loses power, and the red led on the pcb board is blinking. Battery is fully charged, it lifts of at about 10-15 cm, and then the motor loses power until it stops with the red led on the board starting blinking. The blue led which is beside it it remains blue. Would it be the esc? Or could it be the motor? I have checked the esc for a bad connection everything seems fine. And the motor also looks fine. Any suggestions? And recently I’ve got 8 new batteries for it!
You must Sign-in or Register to post messages in the Hobby Squawk community
Registration is FREE and only takes a few moments
