Can someone tell me how to program crow in my DX9,I have a 6 ch rs with flaps and alerions with Y connector on the flaps>
-
-
First of all, welcome to Hobby Squawk!!! Glad you are here.... Using a six channel receiver, you can't do crow... I will find you the correct setup, but the right aileron has to be on channel 2 and the left aileron has to be on channel 6 (Aux 1)… Please stand by... :Cool:
-
I say with a six channel you can't. But more info is needed. Since you have flaps, I am thinking warbird. What type of aircraft do you have, and how many ailerons? 2 or 4? Retracts? If you have flaps and retracts, then we are out of channels for crow...
Comment
-
I was going to try on my Timber, two flaps and two alerions?
Comment
-
OK. That leaves the gear channel (5) free. You can do the starboard aileron (right) in the aileron receiver channel. Then do the port aileron (left) in channel 6 (Aux 1). Leaving channel 5 (gear) for flaps. But by doing that, you will have to reassign the switch functions on the TX to do what you want it to do...
So channel 5 would have to be assigned to switch D for a 3 position flap switch. (That is normally Aux 1 or channel 6)… Then in the system menu, access Aircraft type and select 2 Ail 1 Flap to make it all active. Then you go to flap system and set your flap throws and speed....
Comment
-
Then you need to set a switch for the crow function... After the switch is set, then you adjust your throws for the ailerons in the UP position for both port and starboard. A lot to do, I know... Here is a link for the DX-9 manual and page 33 starts with some basic info. The aircraft type could be set to sailplane for more crow functions, but I have not done that myself....Comment
-
Thank you so much, I will digest this and give her a try!Thank you!!Comment
Comment