Noobie to RC air but so far loving it besides getting through these learning curves, as above can’t get this to bind. I have a DX6e(haven’t updated firm yet) and recently just finished building a FunJet Dragon PNP with a RX600SP. Watched the videos, read the instructions, can’t figure this out. I am attempting to do this with gyro/Rec method on and the program for it is already setup.
The RX is mounted and servos plugged in, I put the bind plug in that came with the receiver, put power to RX, turn on TX while holding bind and bind failure after 5secs apx. Tried different distances, tried no prior model setup for gyro/stab, all batteries are charged, I’m cluesless.
The RX is mounted and servos plugged in, I put the bind plug in that came with the receiver, put power to RX, turn on TX while holding bind and bind failure after 5secs apx. Tried different distances, tried no prior model setup for gyro/stab, all batteries are charged, I’m cluesless.
Comment