Spektrum Forward Programming Discussion (AR630/AR637T)

[kallend]

No, I have the cortex gyro in my 40% pilot Edge 540. I'm using the AR8020T.
you know though you were right. Somehow I got AS3X in with safe.... I did a factory reset and program it without safe and put the gain on my right knob on my dx9. Everything seems to work great. I will first fly my Flex innovation Vintique without the AS3X activated.
thanks for the advice and all the help.

Good.

It seems complicated the first time or two you set one up, but once you get the hang of the logical sequence of steps you'll find it becomes quite easy. I can set up a new model using forward programming in about 10 minutes now.

Remember that if you have to change something, like a channel assignment, wing type, servo reversing, etc. you will need to go into forward programming and "relearn servo settings".

[Cactus Bobby]

Okay thanks for that relearn servo setting. I knew you had to do something but was going to have to go back in the book. Glad you told me that. Thanks a lot

[kallend]

Okay thanks for that relearn servo setting. I knew you had to do something but was going to have to go back in the book. Glad you told me that. Thanks a lot

It's a whole lot easier than with the previous generation AR636, where changing stuff like that, or moving the RX to a new model, was a real PITA.

[rallitiffany]

Hello all,

I have a problem with my AR637TA,
is not my first,but by this receiver make problems:
I create a new model,after maiden flight I go to Forward programming,activate AS3X and Save,
after rebooting the receiver I can`t give Throttle,
Servo Monitor show correct sign,but Motor shows no reaction.
Can anyone me help???
My Transmitter is NX8
all updates for Transmitter and receiver performed

Best regards from Germany

Ralph

[kallend]

Hello all,

I have a problem with my AR637TA,
is not my first,but by this receiver make problems:
I create a new model,after maiden flight I go to Forward programming,activate AS3X and Save,
after rebooting the receiver I can`t give Throttle,
Servo Monitor show correct sign,but Motor shows no reaction.
Can anyone me help???
My Transmitter is NX8
all updates for Transmitter and receiver performed

Best regards from Germany

Ralph

That seems like an ESC problem. Have you calibrated it?

[rallitiffany]

I just tested it and it can't be calibrated
I'll order a new one. I'll report back then

Thank you for the tip

[rallitiffany]

Now I have a new ESC installed and calibrated,
now its works fun

Thanks for thr Tip