Looking for some direction, have installed the Ar636 receiver into the Avanti, servo test on rudder works fine, servo test on nose gear fine, when I plug these into the circuit board on the plane, all surfaces are working correctly except the rudder. The rudder will only turn in one direction if looking at the back of the plane when I push the control on the radio to the right the rudder only goes to the left, nose gear also will not go to the right. I have tried a y harness plugged both leads from the rudder and nose gear to a servo tester and they work fine, plug that into the receiver and I get the same issue.
Thank you for the assistance
Joe
Thank you for the assistance
Joe
Comment