I recently bought the Freewing F-22 150A Brushless ESC for 8S Power Systems and installed it. After installation I recalibrated it (radio on, then hooked up the batteries to the airplane then 2 beeps then zero throttle) but am still getting irregular results. When I hook up the 8S batteries (2x 4S 5000mAh) I only get a double beep then a single beep from the ESC. On every other electric plane I have, after plugging in the batteries I get the corresponding number of beeps for each cell battery I’m using. Is this correct? Anyone else experiencing similar results and what did you do to resolve this issue?
-
-
Is your throttle trim tab set to the bottom? I would re-bind with the trim down low first. You can also do the binding and then the throttle calibration (bind plug removed) with a single 4s or 6s battery. Once successful, hook up your 8s configuration. If there is a problem now, then you may have a problem with the serial battery adapter. I've just finished my F-22, 8s and not a problem with any of it. -
Will try your recommendations and respond back. ThanksComment
-
So on your set up with 8s are you getting 8 beeps?Comment
-
The beeps on this ESC are a little different. when plugging in an 8s pack you should get one long beep to signify 5, followed by 3 beeps to add up to 8. a 6 cell would give you one long beep followed by one short beep...etc....
I've got two of these ESCs that work this way and it confused me at first. Here's a link to the manual for that particular ESC:
Comment
Comment