P-38 - The Ultimate EPO Lightning

Freewing/Hobbywing Skywalker V2 reversing ESC - programming

Collapse
X
Collapse
First Prev Next Last
 
  • Time
  • Show
Clear All
new posts

  • Wingnutz
    replied
    Originally posted by kallend

    Seems like a Lemon problem, not an ESC problem.
    Thanks…Solved…simply switched the reversing lead to aux1 so it stayed plugged in for bind.

    Leave a comment:


  • kallend
    replied
    Originally posted by Wingnutz
    First time squawker here bringing a problem with a HW Skywalker and an Admiral Stab+ rx. Programmed the Skywalker for reversing using the program card recommended in this thread. Plan to use aux2 for the reversing lead but used that port to bind, ergo no reversing lead when binding. Bind went normally followed by plugging reversing lead into aux2. Everything worked fine…esc armed, full stab function, reverse works, flaps work, control surfaces normal…Great!…
    However, after de-powering and re-powering the model, the esc will not arm.
    Powering up with either stab dip-switched off or reverse unplugged allows the esc to arm, but if both are enabled, esc will not arm…help!
    Seems like a Lemon problem, not an ESC problem.

    Leave a comment:


  • Wingnutz
    replied
    First time squawker here bringing a problem with a HW Skywalker and an Admiral Stab+ rx. Programmed the Skywalker for reversing using the program card recommended in this thread. Plan to use aux2 for the reversing lead but used that port to bind, ergo no reversing lead when binding. Bind went normally followed by plugging reversing lead into aux2. Everything worked fine…esc armed, full stab function, reverse works, flaps work, control surfaces normal…Great!…
    However, after de-powering and re-powering the model, the esc will not arm.
    Powering up with either stab dip-switched off or reverse unplugged allows the esc to arm, but if both are enabled, esc will not arm…help!

    Leave a comment:


  • kallend
    replied
    Update: I contacted Hobbywing and the response was that the correct card for the Skywalker V2 (and presumably the Freewing reversible) is:



    Although the Skywalker is not listed on that product page.

    Leave a comment:


  • kallend
    replied
    I just heard from another modeler using a Spektrum system that he too couldn't get the new Hobbywing V2 ESC into programming mode, He eventually did it using a Frsky system.

    Leave a comment:


  • Freewing/Hobbywing Skywalker V2 reversing ESC - programming

    The new FW reversing ESC (which appears to be the same as the Hobbywing Skywalker V2) is in several new and updated EDFs from Freewing.

    If trying to program it with the programming card, the current one listed on MRC's site doesn't work. No new programming card is listed yet.

    If programming the ESC using the transmitter method and using a Spektrum transmitter, be aware that the default Spektrum pulse length at full throttle (1.9ms) may not be long enough to trigger entry to programming mode. On a Hobbywing I couldn't even enter programming mode when increasing the Spektrum's throttle channel "travel" to its maximum. I had to use a servo tester with pulse length 2.2ms before I could get the ESC into programming mode.

    If anyone knows of a programming card that works with the new ESCs, perhaps they would let us know.
Working...