Freewing a10 80 mm nose gear retract only

[mclennr]

I need help to figure out what the part is I need to order to replace the nose gear retracts. I dont need the wheel and down structure. Only need the servo. The black plastic is all cracked. Thanks,

[Reptielenfreak]

You need a 17gr digital MG servo - possitive with a 600mm cable

[Reptielenfreak]

Thats the SKU MD31172-600

[mclennr]

I’m looking for the 90 degree retract hardware with long wire. The door and steering servo are good so far. Thanks, for the reply on that. Only want the black part not the other parts as they are in tact.

[Reptielenfreak]

Oke, because your first message states:" i only need the servo". Also i was refering to the servo that makes steering the nosegear possible not the gear Doors.
Then you need this one..

https://www.motionrc.eu/products/freewing-electronic-retract-with-5-1mm-diameter-shafts-type-c-et8401

[mclennr]

That’s the part. Thank you very much. I’ve ordered the plastic one. Do these parts come in metal or is plastic better as it breaks versus the foam plane?

[Reptielenfreak]

I dont really understand the question.. the outside is plastic, the connection pins etc are aluminium

[mclennr]

its cracked and wobbles when set in place. The plastic housing is the only thing that needs replacing. Everything else works fine. That’s what always breaks.

[Reptielenfreak]

Did you add the nose brace? I have a lot of flights on my a10 but when i installeren the brace and trailing LinkedIn gear i had no problems with cracked plastic casing

[mclennr]

The metal u shaped piece. It was factory installed. Will see what happens after next few flights.
do you stack your batteries or position them end to end in fuselage?

[Reptielenfreak]

The metal u shaped piece. It was factory installed. Will see what happens after next few flights.
do you stack your batteries or position them end to end in fuselage?

No, behind one another.