I have the Freewing F-16 Falcon V3 6S High Performance 70mm EDF Jet - FJ21115P and have enjoyed the model. The first flight was not great, as there was an issue between iX-14 and AR637T with satilite rx. That aside, after several flights, the nose gear servo started to act up. After investigating the issue, I found the wire to the servo pinched against the plywood that holds the steering servo.
Three photos show the issue. One shows the servo with wire against the board. The next shows the wire, out of the servo, that is pinched. The last is showing the cutout in the ply, where the steering servo mounts.
Make sure you check that wire in your model.
Three photos show the issue. One shows the servo with wire against the board. The next shows the wire, out of the servo, that is pinched. The last is showing the cutout in the ply, where the steering servo mounts.
Make sure you check that wire in your model.
Comment