Heng long 7.0 mfu issue.

[tmodel66_71]

I just to say that I love my 1/16 scale heng long tanks!! And this new tank hobby.
I have 2 and they are the m1a2 abrams and the king tiger. But I do have a question. I have had a issue of the wires coming out of the mfu on both tanks. Affecting the ir ability of the tanks. I fixed them, but am concerned that the wires my come out again. So I was wandering if I can use hot glue on the plugs to keep them in the mfu ? Thanks.

[Operator7G]

As long as the plugs are firmly seated when you apply the hot glue, it shouldn't be a problem. I found that the plugs for the stepper motors on my 3D printers were hot glued to the board from the factory. Just don't go overboard, or you'll have a hell of a time removing them when you want to.

[tmodel66_71]

Ok. Thanks for the info.
You guys are great!!