Not sure if retractable landing gear is connected properly to rule out servo failure.
Equipment: Futaba 6J-2.4GHz 6-Channel; Receiver R2006GS 6-Channel; Microbeast Plus v5.1.
With all connections made only 2 channels remain open / unused: the BAT on receiver and SYS channel on the Microbeast.
Futaba manual covers retractable landing gear in aircraft mode (channel 5) but not discussed in helicopter mode.
When plug into channel 5 the retractable landing gear is non-responsive in both aircraft and helicopter mode. Channel 5 in heli mode controls Gyro sensitivity which might be needed.
BAT nor SYS controls retractable gear when used.
Even made changes within transmitter that control channel 5 - still no response from landing gear servo.
Any assistance is greatly appreciated. Thank you in advance.
Equipment: Futaba 6J-2.4GHz 6-Channel; Receiver R2006GS 6-Channel; Microbeast Plus v5.1.
With all connections made only 2 channels remain open / unused: the BAT on receiver and SYS channel on the Microbeast.
Futaba manual covers retractable landing gear in aircraft mode (channel 5) but not discussed in helicopter mode.
When plug into channel 5 the retractable landing gear is non-responsive in both aircraft and helicopter mode. Channel 5 in heli mode controls Gyro sensitivity which might be needed.
BAT nor SYS controls retractable gear when used.
Even made changes within transmitter that control channel 5 - still no response from landing gear servo.
Any assistance is greatly appreciated. Thank you in advance.
Comment