Hello. I know this topic is about my motor but it is from my Roban 700 Apache build. So I’m hoping to get a little help. I installed several upgrade parts in my mechanics including a new main belt. I put it all back together and test ran it on the bench. After about 30 to 45 seconds the shaft on the motor broke. I’m going to assume that I tightened the belt too tight. I have the aligne 800 MX 520 KV motor. So I have a couple of questions.
1. Does anyone know if the shaft can be replaced on this motor? If so is there an instructional video somewhere that someone can link to? I’ve searched on YouTube and can’t find one specific to this motor.
2. Secondly, in general, is this motor OK for this build? If I have to purchase another motor what would be the suggestions?
thanks.
1. Does anyone know if the shaft can be replaced on this motor? If so is there an instructional video somewhere that someone can link to? I’ve searched on YouTube and can’t find one specific to this motor.
2. Secondly, in general, is this motor OK for this build? If I have to purchase another motor what would be the suggestions?
thanks.
Comment