Warning: This clip can make you dizzy... it made me dizzy while filming lol.
A very short clip of the red and white drag chute.
Announcement
Collapse
No announcement yet.
Freewing F-4 drag chute mod
Collapse
X
-
Just finished up a red and white drag chute. Try not to get dizzy lol.
- Likes 1
-
I just ordered a spare tail section for my Phantom in anticipation of Steve's chute mod short kit! :)
- Likes 1
Leave a comment:
-
-
With everything I have going on I may not get to try it until Nall.
Leave a comment:
-
Moving right along...
Initially I relocated the rear hard point but after joining both halves of the FG tail cone realized that the bottom foam piece could just be slid under the edge of the FG part to hold it which worked great. The short kit would contain a strip of FG cloth to join the two halves after you have positioned them and sanded the mating edges flat. I just used CA to saturate the cloth and join the parts. By the way, the FG parts are made with epoxy resin.
Then I took a piece of Estes BT-55 rocket tube I had lying around and kinda formed it into a rectangle. Doing this helped it fit inside the tail cone better. A 2" long piece is provided in the short kit as well.
Placing the tail cone in place over the cardboard tube allowed me to see where it came to to help determine where to cut the hatch.
You can see here where I decided to cut it. I used a razor saw to make the cut
The short kit will also contain the hinge and small screws to help secure it as well as 4 small neodymium magnets and a piece of 1/8" light play to install in the hatch. It must be flush so as not to snag on the chute. I fitted some small scraps of wood to fill the space between the top of the cardboard tube and FG tailcone. Once the glue was all set I drilled some 2mm holes in the wood plate on the hatch cover and in the filler pieces to glue the magnets in. Be very careful with the magnets. They are very small and can end up stuck to who knows what. Also be mindful of their polarity. If installed properly they should be adequate to hold the hatch shut until the chute pushes them apart.
- Likes 1
Leave a comment:
-
-
-
-
Freewing F-4 drag chute mod
I am creating this thread to assist anyone who wants to make the drag chute mod on their F-4 Phantom. I will be posting photos and instructions and I am able to provide the fiber glass tail cone parts and some other bits and pieces in a short kit. You would need to source some micro servos and a few other items to complete it. The chute can be provided by Paul Helms (Helmsman52) and is truly a work of art if you desire a more scale ring/slot style chute. Paul and I collaborated extensively on the design of this very simple yet effective system and I couldn't have done it without his input. Thanks Paul! I will be adding to this soon but wanted to get the thread started for now. Higher and higher, straight up we'll climb!
Tags: None
- Likes 7
Leave a comment: