This is my second scale project. I'm using the Chaos 600 esp air frame. With the mechanics out of the fuselage and attached to a couple pieces of wood. It flies great. Can do some sport flying with it. Once in the Fuselage I have a wobble during flight and hover. I'm using a Beastx gyro and have had good success in the past with the product. I have spent months trying to get the wobble out. Does anyone have a Beastx setup that works, I would like very much to compare.
-
Several 450 pod & booms, Chaos 600, UH1N, MD500, Talon F1, Escapade MX, Avistar, Ugly Stik and Several Foam War Birds -
Do you have any video of the flight? There is more than one thing that can make it wobble -
Your Chaos 600ESP is fine. So did you fly this frame as a pod and boom? I can help you out with your chaos. Like JFandL said theres a lot to it causing your head to wobble. Check your main shaft, your head phasing, tail boom bearings and your torque tube shaft. Let me know.Comment
-
Sorry I have been away for so long. I did figure out what was wrong. After much expense all new shafts all new bearings and different heads and tail feathers. I changed the dampers in the head to 80. that seemed to help a little. The fix was a program change in the BeastX. Changed the Control Style from Sport to Pro. I think I'll remember that one. Hovers like a rock, flies real smooth. Way better than I ever expected. Expensive lesson. Hope this helps....Several 450 pod & booms, Chaos 600, UH1N, MD500, Talon F1, Escapade MX, Avistar, Ugly Stik and Several Foam War BirdsComment
-
Live Q&A every Tuesday and Friday at 9pm EST on my Twitch Livestream
Live chat with me and other RC Nuts on my Discord
Camp my Instagram @Alpha.MakesComment
-
USB, I Have tried Bluetooth but have only had reliable success with AS3X AR636 and AR7200BXSeveral 450 pod & booms, Chaos 600, UH1N, MD500, Talon F1, Escapade MX, Avistar, Ugly Stik and Several Foam War BirdsComment
-
Gmack
No I am able to slide the Tail on with the 45* gear boxSeveral 450 pod & booms, Chaos 600, UH1N, MD500, Talon F1, Escapade MX, Avistar, Ugly Stik and Several Foam War BirdsComment
-
Hello. I am also starting in a 600 Roban UH-1. Using PhoenixTech 600 ESP.
just curious if you all recall how much (if any) nose weight was needed to balance CG.
Doing some planning and was hoping to get an idea how much weight I may need to hide.
many thanks!!Comment
-
On my Roban Bell 212 civilian version I had no cockpit and placed my 720g 5000 60c lipo in that area, it was just very slightly tail heavy, it's the same build as the UH-1, just to give you an idea anyway.Comment
-
Question, the stock Roban frame width expectations are based on a 47mm width. The later Trex and PhoneixTech 600ESP are 54mm.
I have the spacers etc for tail rotor bearing plates, but in doing some checking with 54mm spacing the frame mount lug holes are too wide for installed T-nuts.
i am thinking perhaps to locate them agains the inside frame wall as they are 2mm thick so that looks like it would be enough.
anyone else do something different??Comment
-
Slowly getting there.
Comment
Comment