I programmed reverse thrust on my 70mm Viper an switch g position 1.The next flight it may be on position 0 or 2 you never know where it's going to be the next flight what's up with that.
-
-
Can you elaborate what kind of RX you're using, which channel on the RX you have the single reverse wire plugged into? For now, here's a guess ................................
1. Is the reverse wire plugged into an otherwise unused channel?
2. Is the reverse wire plugged in such that the single wire is the "signal" wire and NOT plugged into the "ground" pin?
3. Did you go into "channel assign" in the system menu to tell it you want switch G to control the channel you have the reverse wire plugged into?
4. If you use reverse on one flight and then go and pick up the plane where it stops and do not put the switch back to forward, the next flight, it defaults to forward even though the switch is in reverse. -
I'd run the update from Spectrum. You'll go from an NX8 to an NX8+ for free, got to like that, it might help.
Here's some guidelines, I followed this and upgraded a friends NX8
Grossman56
(Dangerous Dan)Team Gross!Comment
-
Most common cause of this kind of behavior is that you have inadvertantly got more than one input into the reverse thrust channel.
Post your NSPM file, then we can look at what you did.Comment
Comment