Need pictures of HL M26 Pershing interior with 6 or 7 control board

[RonV]

I'm changing out electronics to 7.0, and I can't figure out where to locate the board. The old board was smaller and sat in one of the bays next to the battery box.

[keilau]

I'm changing out electronics to 7.0, and I can't figure out where to locate the board. The old board was smaller and sat in one of the bays next to the battery box.

I have a very old 2005 Pershing. The electric evolved from TK-27 to TK-5.3 and finally TK-6.0S. You can position the TK-7.0 MFU the way I position the TK-6.0S.

[RonV]

I have a very old 2005 Pershing. The electric evolved from TK-27 to TK-5.3 and finally TK-6.0S. You can position the TK-7.0 MFU the way I position the TK-6.0S.

Is that the same speaker in the first picture that's sitting next to the battery box in the other two pictures.

[keilau]

Is that the same speaker in the first picture that's sitting next to the battery box in the other two pictures.

The original round speaker is too high for the side space. You need the thin rectangular type 2 speaker. Alternatively, you can use the original speaker without the enclosure.

[keilau]

The US Army Pershing is an end of WW2 designed medium battle tank. It is a small chassis for 1/16 scale RC tank. When I upgraded the electronics, I encounted some challenges, but nothing unresolveable. I posted some of my upgrade in this thread.

https://www.hobbysquawk.com/forum/rc-cars-tanks-trucks-and-more/rc-tanks/361006-official-heng-long-1-16-scale-usa-pershing-battle-tank-discussion-thread/page2

I also added barrel recoil to the antique Pershing.

https://www.hobbysquawk.com/forum/rc-cars-tanks-trucks-and-more/rc-tanks/378233-heng-long-metal-barrel-recoil-bb-shooting-unit-upgrade-kit

[RonV]

The original round speaker is too high for the side space. You need the thin rectangular type 2 speaker. Alternatively, you can use the original speaker without the enclosure.

Thanks for the Photos and speaker info. It helped a lot.