Originally posted by SoCalBobS
View Post
-
For the hatch, there is another setup. There are 3 wires (right side in the picture). The black and white go to L10 and the red goes to + pin of CN17 (review board picture in previous post).
SoCal RC Tank Club Facebook Group
Largest active RC Tank club in Southern California
Gathering 1-2x monthly/All Ages & Experience levels welcome -
Hi everyone, I'm new here and have a question about the auto cannon. I was messing around with the settings and turned mine off so it only has the sound and light now. I did a system reset but that still didn't help. I've tried every combination that I could find on motion RC support page for this tank and nothing works. I can't find my original paperwork that came with my IFV. Can anyone tell me what I'm doing wrong? I would really appreciate it! This was one of the very first Bradleys they made if that helps. I've been out of the hobby for awhile and just started to get back into it, I just finally finished my Merkava that's been sitting for almost two years! I was airbrushing the Bradley and setting some of the sounds when I messed it up....Comment
-
A couple of things to try; V & B toggles the Tank vs IFV mode. T & B toggles the BB launch mode. (B is right top button.)The more screws it takes to reassemble a tank, the more likely it is you left something out!Comment
-
Thanks for replying! Unfortunately it didn't work. Doing both of those things did not change anything..... The tank did not change in anyway...
This is so frustrating!Comment
-
Update!
I couldn't get it to work until I held down B then V!
Thank you so much for helping me!Comment
-
Comment