M2 Bradley by Tongde

[DavidN]

Thanks! What channels were the periscope and hatch plugger into?

For the hatch, there is another setup. There are 3 wires (right side in the picture). The black and white go to L10 and the red goes to + pin of CN17 (review board picture in previous post).

[Beavis991]

Hi everyone, I'm new here and have a question about the auto cannon. I was messing around with the settings and turned mine off so it only has the sound and light now. I did a system reset but that still didn't help. I've tried every combination that I could find on motion RC support page for this tank and nothing works. I can't find my original paperwork that came with my IFV. Can anyone tell me what I'm doing wrong? I would really appreciate it! This was one of the very first Bradleys they made if that helps. I've been out of the hobby for awhile and just started to get back into it, I just finally finished my Merkava that's been sitting for almost two years! I was airbrushing the Bradley and setting some of the sounds when I messed it up....

[SoCalBobS]

A couple of things to try; V & B toggles the Tank vs IFV mode. T & B toggles the BB launch mode. (B is right top button.)

[Beavis991]

Thanks for replying! Unfortunately it didn't work. Doing both of those things did not change anything..... The tank did not change in anyway...
This is so frustrating!

[Beavis991]

Update!
I couldn't get it to work until I held down B then V!
Thank you so much for helping me!

[Dongskie2]

Update!
I couldn't get it to work until I held down B then V!
Thank you so much for helping me!

Any luck?

[Marc780]

A quick clip to show it runs. You can see a large gap in front between the upper and lower hull. There is a plate that I haven't fitted yet that covers it. I thought for a minute it was a major flaw, but all is good.

Yep, I noticed that gap happened after I opened the Bradley IFV tank to install metal gearboxes. I almost destroyed the upper hull trying to fix that gap which made me finally rethink the whole repair!
Finally I fixed it by gluing on some square plastic tubing (From Az) on the upper hull and covering the seam with Tamiya putty. A little Desert Tan paint and drybrushing a bit of dirt and here's how it came out