Originally posted by Thegecko
View Post
Announcement
Collapse
No announcement yet.
Avios/Hobby King 1600mm C-130 Hercules
Collapse
X
-
-
to close the inner flap due to servo travel I had to set sub trim at 225 the maximum and trim at 64 to close the flap right up. Downside very little movement on the flap when using it. On another point, what is the best spot to situate the receiver? They say to get it as close to the cg as possible for the gyro. There is not a lot of room close due to the main board on the roof and landing gear in the floor.
Comment
-
Originally posted by Thegecko View Postto close the inner flap due to servo travel I had to set sub trim at 225 the maximum and trim at 64 to close the flap right up. Downside very little movement on the flap when using it. On another point, what is the best spot to situate the receiver? They say to get it as close to the cg as possible for the gyro. There is not a lot of room close due to the main board on the roof and landing gear in the floor.
Don't stress too much over where the gyro goes. Putting it near the CG is "old school". Many planes that come with gyros these days have them mounted nowhere near the CG and they work just fine. My RX is far in front of the battery straps and my gyro is beside the RX mounted next to the side wall. The plane flies very solid even in some stiff winds.
Comment
-
Originally posted by Thegecko View PostHi Guy's, I am using a Spektrum AR8360T receiver. When I to go into the system menu the engines and and lights kick in, when I back out they stop. Attempted to upload a video of it without success. Anyone else have this issue?
Comment
-
Originally posted by Thegecko View PostHi Guy's, I am using a Spektrum AR8360T receiver. When I to go into the system menu the engines and and lights kick in, when I back out they stop. Attempted to upload a video of it without success. Anyone else have this issue?
Comment
-
Originally posted by lusek_pl View PostHello everyone. I would like to share the issue of loose controls in the C 130. I purchased the model more than a year ago and it was my big surprise when there were loose elevator and rudder when folding. Reading the forum you can see that the problem is not unique ... I decided to fix it in a good way not to come back to it. I peeled off a piece of foam on the steering enhancement. There is a carbon tube on the elevator, right next to the hinges, you need to be careful. It turns out that friends from the Far East stuck the halves of the steering wheel together, but they did not glue into the hinges, so they are loose. I invite you to the movie, best regards
https://youtu.be/75bnf26Dz98
- Likes 1
Comment
Comment