210 results in 0.0099 seconds.
-
The ar10360T rx is bound but all I get is a single beep from the motors and nothing else, any ideas? -
Can't find it yet online (AliExpress, Taobao, etc.). No official word, but my sources tell me that Motion RC is planning to offer them, maybe in 4 to...Leave a comment:
-
In my profile picture? It the Freewing A10 80mm....Leave a comment:
-
That wedge can't hurt but it really doesn't do anything with regards to the gear collapse. It was a premature "knee jerk" response to a problem...Leave a comment:
-
Thanks xviper , should get it tomorrow so will have good look inside the nose bay area. I believe a wedge was inserted under the retract to angle the...Leave a comment:
-
I tried magnet on 2 of my heng long using the strongest magnet I can find. The matching is not precise and the attachment is weak. It bunces off too easily....Leave a comment:
-
Some screen captures. Credit to Eric Peng on FB.
...Leave a comment:
-
Y'all,
And if you're still reading this thread, the photos below are from the same time period 1984-5.
That's me in the light...Leave a comment:
-
Opel Blitz by Coolbank
I just ran across some info about the Opel Blitz by Coolbank. It's apparently finally available, but I don't have info as to where yet. Here is a screen... -
Maiden flight day for both of our 110mm F-35s is complete. What a great jet. Check out our tandem flight. I hope that this time MotionRC...Leave a comment:
-
There are 2 of these planes at our field. Mine is one of them. Both are the HobbyKing V1 and both had very weak nose gear that easily collapsed with...Leave a comment:
-
Have you done the "throttle calibration"?...Leave a comment:
-
With those motors and the recommended ESCs (65A), 10x7 props should not be a problem on 4s.
As an after thought, since you're all set up...Leave a comment:
-
Old Bold (R/C) Pilots
Hey all,
I ran across some photos I had taken at the 1984 US Scale Masters in KC MO.
Seeing these two guys was like seeing your... -
I'm trying to get out of using a channel just for the lights....Leave a comment:
-
I bought the Old crown P51 sometime ago, and got the wrong version, so after finally also getting a Futaba compatible radio we were ready to fly.
...Leave a comment:
-
This is where you get creative. I have used Magnets and even Lego pieces to attach upper and lower together....Leave a comment:
-
I do have a 4s pack, just worried about overspending the props. That’s around 16k RPM. I’ll try a good taxi test...Leave a comment:
-
Danger,
Ah yes, the "Kermie Cam"...great videos.
Are you going to detail out the cockpit and forward gunner's office?...Leave a comment:
-
Elbee commented on Guest's to Official Freewing 110mm F-35C Lightning II Super Scale EDF Jet Threadin RC JetsHi, did you use aileron mixing? V-tail? -
Guys ,
Can we confirm if the CHNL v1 version has the nose retract issue addressed or not ?Leave a comment:
-
Mine is not delivered yet but you say those lights are on a switch, right? Why don't you just leave that switch in the ON position? When the battery...Leave a comment:
-
Are you using the correct email for her ............................................ info@callie-graphics.com
Typed correctly? It's a hyphen, not...Leave a comment:
-
Davegee,
I believe there is one in the national museum. RexLeave a comment:
-
Grossman 56,
Your rebuild is amazing. You are a foam craftsman. Better be careful when it's finished Dave will pry it out of your hands yelling...Leave a comment:
-
Maidened today and managed to get 7 total flights. I flew 25-30mm aft of the marks. What a great flying plane, power for days, good behaviors all around....Leave a comment:
-
Formation Light Controller
Does anyone know if there is a way to have the formation lights unswitched....so they are on any time the batteries...Leave a comment:
-
I added some more decals and did some detailing with red paint on the fuel tank mounting straps, air cleaner intake, .50 cal and mini gun mounts, and...
Leave a comment:
Leave a comment: