Spare parts are in get them while they last!
Announcement
Collapse
No announcement yet.
Official FlightLine OV-10 Bronco Discussion Thread
Collapse
X
-
Im doing the DS 91' scheme and came up with an idea using my Cameo 3 cutter. I use a flat white vinyl to cut the frame and then paint it after weeding out all the slots. I cut a black under layer that is placed first then the frame over that on the model. The screws on the perimeter are done with a fine tip perm maker. This gives a slight 3D effect and is very subtle but i never could get my 3D printer to do a presentable job with such thin wall thickness between each slot.
I like to know if anyone may be interested in a set for $5 mailed.
Im also working on decal printed wing fuel caps that would be the whole access panel and the fuel symbol and wording. In my reading on Bronc's in DS, they were hastily painted and most of the nomenclature was left off other than the ones that mattered.
Im printing my fuse nomenclature and will post what that looks like when applied.
On that note, i printed the wording both ways on the clear decal sheet, reversed and normal. Has anyone used the reversed application method in that the decal film would be over the printed media and the decal is applied with a clear paint media to the surface??????
Comment
-
Wing fuel panel.
Two layers of vinyl with the top layer with a relief cut where the fuel cap is to give a recessed look that the cap is slightly below panel. The sealant, cap and wording is reverse printed on clear decal film and placed face down. Once all is placed then flat clear coated. The decal will work on any scheme andalso i can scale up to be used on the Nexa Bronco.
Comment
-
finally took mine out of the box and put it together the wireing is something to behold...not hard to do if u watch the vids though...this is the first model i put together using the blue box as i usually Y harness and throw out the box..ill get around to flying it sooner then later...this is a nice large plane if it flys half as good as it looks iam going to be a happy camper
if painting wasent so hard to do in my limited space id make it a VAL4 black ponies a navy sq from vietnam days..those guys packed the big ones
Comment
-
sam51401
Now that is an ARF Do ya know who makes itWarbird Charlie
HSD Skyraider FlightLine OV-10 FMS 1400: P-40B, P-51, F4U, F6F, T-28, P-40E, Pitts, 1700 F4U & F7F, FOX glider Freewing A-6, T-33, P-51 Dynam ME-262, Waco TF Giant P-47; ESM F7F-3 LX PBJ-1 EFL CZ T-28, C-150, 1500 P-51 & FW-190
Comment
-
Originally posted by MountainRC View PostI believe it’s a hangar 9 and it’s almost the same size as there bigger cub.
Mike\"When Inverted Down Is Up And Up Is Expensive\"
Comment
-
Originally posted by MikeT View Post
I know Rich Uravitch had a large ARF ( and a 81 inch kit) awhile back , but Hanger 9? That one I've never heard about.
Mike
Comment
Comment