Official Freewing 80mm MiG-21 Fishbed Thread

[gooniac33]

I got gobs of flight time with my mig this weekend!! Check out my channel to see them all but here are a couple

[Greyhound61]

Hi fellow pilots, finally I have almost finalized my Czech MiG 21. A bit of weathiering here and there will follow and then the maiden. It is a stock version with small mods as afterburner ring, position and landing lights.

[Boots Whirlygig]

That's a good looking MiG, Greyhound61.

[Greyhound61]

Thank you BW :-)

[gooniac33]

Hi fellow pilots, finally I have almost finalized my Czech MiG 21. A bit of weathiering here and there will follow and then the maiden. It is a stock version with small mods as afterburner ring, position and landing lights.

WOW good looking plane!

[Greyhound61]

Hi fellow MiG pilots, finally the maiden of my Czech MiG 21 this weekend. As already stated in this thread, a very nice plane to fly, no bad habits (sorry, no video, was alone on the airfield). CG at 275mm, flew on low rate (elevator 20mm, aileron 13 mm), Admiral 5000 mAh. Decent rotation on take-off, no jump into the air. Definitely a "keeper". Looking forward to many more flights!

[seaviper]

Looks great!

[crxmanpat]

Greyhound, awesome job on the Czech Mig! Love the weathering detail!

On Friday I got mine down off the ceiling to fly yesterday as it's been a while since she's flown. Before, I had taken a Sharpie fine point and drew in the panel lines. But Friday I went back over her using my charcoal pencil and brush method, and she looks a lot better now. Two great flights yesterday.

[T-CAT]

Greyhound, awesome job on the Czech Mig! Love the weathering detail!

On Friday I got mine down off the ceiling to fly yesterday as it's been a while since she's flown. Before, I had taken a Sharpie fine point and drew in the panel lines. But Friday I went back over her using my charcoal pencil and brush method, and she looks a lot better now. Two great flights yesterday.

Awesome work Pat. I love that paint scheme on the Mig.

[waytooslow]

Killed my beloved MIG at our WarBird event -- watch the Highlights here and you will see it go in hard. see 2:11 So does the fan setup work in any ARF pluses besides the MIG? It about all that survived ---- ready to move on if I can use the EDF and ESC elsewhere/

[T-CAT]

Killed my beloved MIG at our WarBird event -- watch the Highlights here and you will see it go in hard. see 2:11 So does the fan setup work in any ARF pluses besides the MIG? It about all that survived ---- ready to move on if I can use the EDF and ESC elsewhere/

Sorry to hear that man. However, that did go out in style :). That power system should do just fine in any of the FW 80mm ARF Pluses.

[bill34207]

Killed my beloved MIG at our WarBird event -- watch the Highlights here and you will see it go in hard. see 2:11 So does the fan setup work in any ARF pluses besides the MIG? It about all that survived ---- ready to move on if I can use the EDF and ESC elsewhere/

It does work in any Freewing 80 mm. I'm using one in the ARF + Avanti. Might have to change some wire lengths on the ESC (think I shortened them for the Avanti) but other than that it's a drop in.

[gooniac33]

I have tried several different edf setups in my mig. But Now I have found the one that works best! Strangely enough it is from FMS... Dropped right in with minimal foam sanding and it works amazing!! Here are the highlights from this past weekends flying...

[Shirty]

Thought you guys might appreciate a couple of picsof a clubmate playing with his mig21 in his shed. (As you do...). It's not the freewing one sorry, and he's still got a bit of work to do to finish the build, but nice jet all the same. I volunteered to do the maiden for him, but I don't think he's keen...
::)

[RCjetdude]

That is quite the project!

[DCORSAIR]

Thought you guys might appreciate a couple of picsof a clubmate playing with his mig21 in his shed. (As you do...). It's not the freewing one sorry, and he's still got a bit of work to do to finish the build, but nice jet all the same. I volunteered to do the maiden for him, but I don't think he's keen...
::)

If he is going to sell it, tell him $329 shipped I will take it, same price as Motion.... :)

Really must be nice to have Mig in your hanger to play in, wow, you couldn't get me out of that thing..............;):Cool:

[Boots Whirlygig]

The MiG’s got a B-17 parked on its wing!

[Alpha]

WANT.

[RAPHAEL_CINTRA]

Hi,

I am setting up my Mig with the Gyro and I want to set the best servo frequency in the hobby eagle set up. I seem to be getting some pretty poor resolution at 50 hertz. Does anyone know what the supplied motion Rc servos should be run at?
Cheers

Peter

Hey Pete,
I use the A3-L in all my jets and up to know the best configuration is to maintain at 50hertz (even considering that the servos are digital)....i tried to change once and noted some abnormal servos movment.
Cheers

[the snake]