Official 3DP Thread

[Radar-Guy]

Post moved to F-18 thread

[Radar-Guy]

Here are the files. One note: The tiny part on the far left of Overview 3 actually belongs to Overview 2, it's a switch located to the box left of the HUD. The seat is intended to be a replica of the early seats (SJU 5). The seat backrest and rails need to be Z-cut to the desired size.

Fröhliche Weihnachten!

[Radar-Guy]

Second set of files (there's a limit of 20 per post)

[Elbee]

Radar-Guy, Absolutely Fabulous, Sir. Thank you. Merry Christmas to you and yours.. Best, LB

[Ken LaPointe]

Ken, The 2 'green' parts: 1) larger 90 degree part goes above the seat and below the "headrest" with the 90 up and facing forward, 2) the 'channel' part is the back of the parachute box and mounts between the seat rails in those channels against the inside top of the headrest and is the last part I glue in place. The angle for the Headrest can be adjusted some, but fit tight it is mostly correct. I angled mine a bit tipped forward as I liked the look. Hope this helps. Best, LB

Oh, ok, that helps, thanks a bunch

[Dustman]

Kool, this a nice set to have also. What a great Christmas present!!

[Dirty Dee]

So much sanding!

[Elbee]

So much sanding!

DD, Whew and you're not done. LOL. That's a large aircraft, huh? Lookin' Good, Sir. Best, LB

[Dirty Dee]

Some more lightweight filler, a final coat of primer, then some more sanding and pinhole filling

Yes, its quite large!

[rifleman_btx]

I like it, can't wait for the flight video

[Gilatrout]

So much sanding!

Are you hand sanding or using a power sander?

[Dirty Dee]

Are you hand sanding or using a power sander?

All by hand.

[Hardway]

Old school baby!!! Rub rub rub rub rub rub....Repeat...

[rifleman_btx]

Just printed this up tonight just to see if I could. Lol

[Prowler901]

That's awesome! Is that HO scale?

[RRHandy]

Just printed this up tonight just to see if I could. Lol

I have been printing bridges for a buddy of mine's railroad on my Anet A8.

[Elbee]

I have been printing bridges for a buddy of mine's railroad on my Anet A8.

Would like to see some pictures, please. I've been looking at printing some architectural and topography items. I think all of those would be good exercises in design-to-print. Best, LB

[F106DeltaDart]

I have been printing and modeling parts for my OH-58D Kiowa project. Finished printing the Mast Mounted Sight, and painting up the printed pilot figures.

[RCjetdude]

I have been printing and modeling parts for my OH-58D Kiowa project. Finished printing the Mast Mounted Sight, and painting up the printed pilot figures.

Excellent job Michael! Stellar build project. That Kiowa is going to be awesome!

[Elbee]

I have been printing and modeling parts for my OH-58D Kiowa project. Finished printing the Mast Mounted Sight, and painting up the printed pilot figures.

F106DD,Great Work, Sir. You gotta design AO Sunglasses for your helo crew, I know it's not a priority but it would be Sierra Hotel. Best, LB