"Hacksaw the glue? I used foam tac and some gorilla glue. It really wasn’t gonna come off in a hurry."
Cut 1/2" on the far side of the tail with a sharp blade or fine saw as far as the carbon tube but don't cut into the tube. Then, painstakingly remove every bit of foam and glue using any tool that works. Gorilla glue cuts and sands, never used foam tac so can't help with that! Clean the protruding carbon rod ready to insert in the new fuse. If the surface your left with is very pitted use two or three short carbon rods or even round lollipop sticks to secure it. Try to maintain a clean all round edge for cosmetics !! You'll get there .........good luck!!
Cut 1/2" on the far side of the tail with a sharp blade or fine saw as far as the carbon tube but don't cut into the tube. Then, painstakingly remove every bit of foam and glue using any tool that works. Gorilla glue cuts and sands, never used foam tac so can't help with that! Clean the protruding carbon rod ready to insert in the new fuse. If the surface your left with is very pitted use two or three short carbon rods or even round lollipop sticks to secure it. Try to maintain a clean all round edge for cosmetics !! You'll get there .........good luck!!
Comment